Ok, so here's my setup: I just got an i7 iMac desktop, with a time capsule as a back up for time machine. I'm in a situation similar to the original poster, where I'm having issues getting time capsule to be recognized on a device plugged into one of its Ethernet ports. There may be a way to swap DHCP servers but I don't use the public network feature so I haven't looked into it. I had to set the TC to bridge mode and let the Netgear act as the DHCP server for all this to work. The Netgear is not transmitting wireless (I shut it off). The Wireless is extended using Airport Expresses. I have a TC connected to the Netgear router through wired 1G Ethernet - used as the Wireless Base Station, NAS and Time Machine Backup disk. So you cannot use the Time Capsule to extend a non Apple Wifi network, but you can connect it through Wifi (but it won't extend the signal) - The Belkin thing - you probably had to do some other setup in the TC to get the ethernet ports to work - but the TC wouldn't extend the network, just connect to it (Same is true of Airport Expresses)īottom line - I have a main Netgear router being used as a router. That is like my Time Capsule talking to my Airport Expresses. There is a special WDS - Wireless Distribution System - where to extend Wifi you need Apple products talking to Apple products. There is no special Apple wired Ethernet. So absolutely - wired ethernet is wired ethernet and I have a mish-mash of switches from dlink, netgear, linksys, connected to the Time Capsule, and Netgear router - all work. Connected wirelessly and retransmitting the signal are 4 Airport Expresses sprinkled around the house near speakers. So like Bob - I have a netgear main router - that is bridged via 1G Ethernet wired - to a Apple Time Capsule. I think it has to do with the use of the word bridge and ethernet. You can also repeat a signal in theoory with out the cable, have not tried that though as it increases lag, halves the speed, and i have an ethernet cable where i want the router.It seems there is confusion about what the OP is asking. Setup was easy, if u wanna do it that way you gotta connect the WAN port to the upstream router (assuming this is a 2012 airport, else theres only one port so use that one) Also, the fact that it is in bridge means the linksys gives out the IP addresses, allowing for faster roaming (theoretically, have not done testing in the middle of a transfer) I got mine working, Airport express connected via ethernet to linksys router, both running their own WiFi networks with the same SSID's and passwords, allowing devices to roam between them. The network mode needs to be "Create a wireless network," it should Connect Using "Ethernet," and Connection Sharing needs to be "Off (Bridge mode)." Next, when setting up the Express, just set up its Network name and Password exactly the same as the network used by your non-Apple router. Make sure that the main non-Apple router is set to share a public IP address. The newer Airport Express models (the ones compatible with 802.11n) can do this.įirst, you need the Express connected to Ethernet. Otherwise, you can setup a roaming network. However, this is only if your AirPort Express is not connected to Ethernet. Mere minutes away from long-range Wi-Fi enjoyment. Launch theĮasy-to-use AirPort Utility app on your iOS device or Mac, and you’re Near the area where you want your wireless connection. an AirPort Extreme, Time Capsule, or another AirPort Express - and Just place it in range of your primary base station Wireless network in your home and want to extend its range, AirPortĮxpress can help. Apple seems to be saying in a round-a-bout way here that other routers are not supported for wireless range extensions (with a router connected to Ethernet and the Express not): Extend an existing Wi-Fi network’s range.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |